ECLIPSE II / ENTERPRISE II
APPLICATION INSTRUCTIONS 
FOR YOUR
E-Z UP INSTANT SHELTER TOP

Due to damage that may occur as a result of common carrier transportation, we find it necessary to place the top and frame in separate boxes.  The 8'x8', 10'x10' and 10'x15' E-Z Up Instant Shelters are sent in two boxes.  The 10'x20' E-Z Up Instant Shelter is sent in three boxes with a small amount of frame assembly needed.

To begin, assemble your 10'x20' E-Z Up Shelter frame following the assembly instructions provided on a separate sheet, prior to the application of the top.

Instructions:  Read all instructions carefully before you begin.  Open your frame to approximately three quarter of its total size.  Unfold your E-Z Up top and drape over the frame.  Slip the four corners of the top over the four corners of the frame.  Following the Set-Up Instructions label sewn on the cover bag, open the unit completely without extending the legs.

The top attaches to the frame by frame bolts which line up with the attaching grommets on the valance around the perimeter of the top.  Simply remove the bolts (using one 7/16" Hex wrench and one Allen wrench (5MM) provided in your warranty kit)  and slide the bolts through the grommets.  Attach the bolts back to the frame and tighten securely.

         REMEMBER:

         1.  Carefully read the entire Set-Up Instructions label sewn on the cover bag.

         2.  Use the cover bag when the shelter is not in use.

         3.  The top can remain on the frame.

 

Back To Top

Last Revised: February 27, 2006